Checking Power Trim Fluid - Mercury 200 Verado Manual

• Belt surfaces roughened.
• Signs of wear on edges or outer surfaces of belt.

Checking Power Trim Fluid

1. Tilt outboard to the full up position.
2. Rotate the tilt support bracket down.
3. Lower outboard until tilt support bracket rests on pedestal.
4. Remove the power trim fill cap. The fill cap only requires 1/4
turn to remove.
a
a - Tilt support lever
b - Power trim fill cap
5. The fluid level should be approximately 25 mm (1 in.) from the
top of the fill neck. Add Quicksilver or Mercury Precision
Lubricants Power Trim & Steering Fluid. If not available, use
automotive automatic transmission fluid (ATF).
Tube Ref No.
Power Trim and
114
Steering Fluid
6. Reinstall the power trim fill cap. Tighten fill cap 1/4 turn. Cap
will snap in place. Do not tighten beyond this point.
MAINTENANCE
Description
121
b
c - Tilt support bracket
d - Pedestal
Where Used
Power trim system
c
d
ob01526
Part No.
92-802880A1