Mounting The Sewing Lamp; Mounting The Spool Holder; Initial Operation; Switching The Machine On/Off - Pfaff 335 Instruction Manual

8

Mounting the sewing lamp

.01.05
Screw the sewing lamp onto the table top (wood screws 5x35) and have it connected by
a specialist.
8

Mounting the spool holder

.01.06
Mount the spool holder.
Insert the spool holder into the hole in the table top and affix it with the enclosed nuts.
8.

Initial operation

02
Before operating the machine, check the electrical and pneumatic connections for
possible damage.
Clean the machine thoroughly and then oil it (see chapter 11 Care and maintenance).
Have specialist personnel check if the machine's motor can be put into operation with
the power supply available and if the terminal box is connected properly. Never operate
the machine unless these checks have been successfully carried out.
The handwheel must rotate towards the operator when the machine is running. If this is
not the case, have the machine altered by specialist personnel.
Connect the machine to the compressed air system. The manometer must display a
pressure of approx. 6 bar. If necessary, adjust to this value (see chapter 11.06 Adjusting
the air pressure).
8.

Switching the machine on/off

03
Switch the machine on (see chapter 7.01).
Carry out a test run.
The sewing lamp is not included in the standard delivery.
Mounting and initial operation
8 - 4