Name Of Each Part - KOCOM KCV-802R Operating & Installation Manual

Name of Each Part

Monitor
1
7
2
No Name Brief Description
1 Handset used in communication (sending/receiving) between camera and the extension line of interphone
Security/
used in a call to security phone or an incoming call from security or lobby phone
2
Lobby Button
3 Extension used in a call to/from multi-family interphone and OSD menu cancle
Line Button
◁ Left
(A)Pressing this button with the handset being hung up, a user can view images from door camera 1 or 2.)
Button
(B) used as Left button in setting OSD menu.
△ Up (A) saves (RECORD) images from Camera 1 & 2
Button
(B) used as Up button in setting OSD menu
▷ Right (A) plays images saved in standby mode - used as Forward key
4
Button (B) used as Right button in setting OSD menu
▽ Down (A) used as Delete key in playing images
Button (B) used as Down button in setting OSD menu
(A) Entrance into User's OSD (Press the button lightly to enter into User's OSD)
Menu/
(B) Change of User's OSD MENU
OK Button
(C) Entrance into Installer's OSD (Press the button for more than 5 seconds to enter into Installer's OSD)
used in a call and communication with private exchanger
TEL/Absence
5
Button
Door works door open function of camera when a user press this button
6
with communicating with gate camera
Open Button
12 Keys for
If a user presses one or more of 12 keys for extension line after pressing Extension Line button,
7
Extension Line a call signal is sent to a house device or an exchanger phone to which the selected number is assigned.
※In case a trouble arises from the user's arbitrary modification of installer's OSD menu, charges for any after-sales service
(A/S) due to the trouble should be paid by a user even during the warranted A/S period.
12
Front
3 5 6
4
Name of Each Part
Monitor
8 9 10 11
Bottom View
No Name
Tone Ring
adjusts volume of tone ring (low to loud)Volume Switch
8
Modular Jack a jack for handset connection cord
9
Wall-mounting a hole for a screw used in fixation of main body in its wall-Fixation Part
10
Power Switch on/off switch for main power supply for monitor
11
Out Terminal Devices for each of the connection points
12
Output Connection A : Analogue-type Security Master(2P) D : Multi-family Main Wiring(9P)
13
Parts
B : Camera 1(4P)
A B C
C : Camera 2(4P)
D E F
Door Camera
KC-MC30 KC-MC31
1 1
2 2
3 3
4 4
5 5
6 7
FG(FRAME GROUND)
1. C-Mic : To communicate with Monitor
2. Camera Lens
3. LED
4. Speaker : When visitor calls, the voice from monitor comes out of the speaker.
5. Call Button : By pressing the button, the related house will be called.
6. Name plate
7. Screw cap
A B C
D E F
13
Rear View
12
Brief Description
E : Security Sensor(3P)
F : Program write port(7P)
KC-MC30 KC-MC31
① : VCC
② : GND
⑦
③ : Audi o
⑧ ⑧
① ①
④ : Vi d eo
② ②
⑤&⑥ : Door (Non-Pol a ri t y)
③ ③
④ ④
⑦ : Camera angle knob
⑤ ⑤
⑥ ⑥
(Only KC-MC30)
FG(FRAME GROUND) ⑧ : Wi r e cl a mp
13