Monitor Installation; Door Camera Installation - KOCOM KCV-802R Operating & Installation Manual

Installation Precaution
Monitor and camera must be installed away from direct light
●
and counter light.
Camera must be installed at a place free from rain.
●
Standard height of monitor must be 1,450mm~1,500mm from ground,
●
centered around brawn tube.
Camera should be installed on the wall in which cement is completely dry.
●
If installed during winter season at temperature below -5℃ condensation
●
might be generated inside monitor and camera due to temperature
difference between indoors and outdoors.
To prevent breakdown due to such condensation, connection should be
made in 2 hours or more after installation.
Do not install monitor and camera in locations subject to direct heating as
●
harmful gases may subsequently be emitted in significant amounts.

Monitor Installation

1 2
Wall hanger
4X25mm
Screw
4 5
Standard height monitor
Standard height of monitor is ranged 1,450 ~ 1,500 from bottom
●
to the center of monitor screen.
For installation, avoid the places where there is any excessive
●
humidity,magnetic force, dangerous chemicals, direct ray of sun,
and any places near a heater which can cause break down.
10
Stop up P.V.C. pipe using
adiabatic substances, to prevent
air circulation
Stopping up pipe as above minimizes
※
temperature difference between indoors and outdoors,
and also eliminates moisture and condensation on door
camera window.
Rear
3
bracket
6
3X8mm
Screw
Center of moniter
Bottom of
1 Rectangular
switch box

Door Camera Installation

Surface-mounting Door Camera Installation
Wall
Rear Bracket
※Before installation, do not fail to shut the piping.
Standard Height of Door Camera
Standard height of the door camera is 1,400mm~1,450mm from
●
the bottom of one camera to the floor.
In case that the height of Door camera exceeds the range of
●
min. 1,250mm~1,550mm, it is impossible to control the screen
picture with only the lens angle, and therefore, be careful of the
height of camera installation.
END
※CAUTION
Do not install the door camera in the place under direct sunlight shines, it may make faint image
or white stripe or round form line on the image. If this phenomenon appears on the monitor's image,
it is not mechanical trouble, so please replace the door camera to keep away direct sunlight or
change the direction of the door camera.
(unit:mm)
KC-MC30
Wall
Camera
4X25mm
Screw
Wrench
Rear Bracket
4X8mm
Name plate
Screw
Bottom base of
One hall Box
Surface mount
(unit:mm)
KC-MC31
Camera
4X25mm
Screw
Wrench
4X8mm
Screw
Screw cap
11