KOCOM KCV-802R Operating & Installation Manual page 15

Functional Description
4) CAMERA1 O : Select CAMERA1
CAMERA1 X : Not select CAMERA1
5) CAMERA2 O : Select CAMERA2
CAMERA2 X : Not select CAMERA2
CAMERA2 P : Select PIR Sensor Camera (Extra Sale)
After PIR sensor on, the monitor will be turned on during 2' 30''.
(It is possible only for CAMERA2.)
6) MODE MULTI : set for the common gate system products.
MODE PABX : will let the guard master be compatible to communicate.
It is compatible with the common gate products.
MODE ANALOG : set for the ANALOG guard master.
On MODE ANALOG, the call menu will disappear and won't be compatible with the common gate
->
products and serve phone.
MODE Selection can be added according to the firmware version and the function will different according to
※
the selected Mode.
7) PROTOCOL OLD : set for the compatibility with the old common gate systems.
PROTOCOL NEW : It can be set from 1 to 1599 and ID number over 63.
8) DOOR OPEN CAMERA : Output the door open signal to CAMERA 1 and 2.
DOOR OPEN MONITOR : Output the door open signal to MONITOR outside signal point.
Caution: Set to Monitor and DOOR OPEN appears on DEVICE
※
SWITCH ON/OFF.
9) SENSOR NORMAL OPEN : According to the point type of input sensor, set 'normal - opened (not active),
closed (active).
SENSOR NORMAL CLOSE : According to the point type of input sensor, set 'normal - closed (not active),
opened (active).
10) INITIAL MENU SW ENTER: Press the menu for default.
->
Caution for Protocol set of the common gate products
※
Set the entire common gate products with a same Protocol and the call and communication will be possible.
Wrong set occurs malfunction.
28
SWITCH and can not control
->
29