Decal Removal/Application; Removal; Instructions For "Wet" Application - Mercury 40 FourStroke Service Manual

GENERAL INFORMATION
Be sure to comply with instructions on the label for ventilation and respirators. Us-
ing a spray gun, apply one half to one mil even film thickness. Let dry, flash off for
five minutes and apply another even coat of one half to one mil film thickness. This
urethane paint will dry to the touch in a matter of hours, but will remain sensitive
to scratches and abrasions for a few days.
9. The type of spray gun used will determine the proper reduction ratio of the paint.
IMPORTANT: Do not paint sacrificial zinc trim tab or zinc anode.
10. Cut out a cardboard "plug" for trim tab pocket to keep paint off of mating surface to main-
tain good continuity circuitry between trim tab and gear housing.

Decal Removal/Application

Removal

1. Mark decal location before removal to assure proper alignment of new decal.
2. Carefully soften decal and decal adhesive with a heat gun or heat blower while removing
old decal.
3. Clean decal contact area with a 1:1 mixture of isopropyl alcohol and water.
4. Thoroughly dry decal contact area and check for a completely cleaned surface.

Instructions for "Wet" Application

NOTE: The following decal installation instructions are provided for a "Wet" installation. All
decals should be applied wet.
TOOLS REQUIRED
1. Plastic Squeegee*
2. Stick Pin
3. Dish Washing Liquid/Detergent without ammonia.**
** Automotive Body Filler Squeegee
** Do not use a soap that contains petroleum based solvents.
SERVICE TIP: Placement of decals using the "Wet" application will allow time to posi-
tion decal. Read entire installation instructions on this technique before proceeding.
TEMPERATURE
IMPORTANT: Installation of vinyl decals should not be attempted while in direct sun-
light. Air and surface temperature should be between 60 F (15 C) and 100 F (38 C)
for best application.
SURFACE PREPARATION
IMPORTANT: Do not use a soap or any petroleum based solvents to clean application
surface.
Clean entire application surface with mild dish washing liquid and water. Rinse surface thor-
oughly with clean water.
Page 1C-22
CAUTION
90-857046R1 NOVEMBER 2001