Assembly Of The Remote Cable - Scott Genius LT Owner's Manual

SCOTT offers 2 different TWINLOC levers with following fork/rear shock
combinations:
- FOX Nude with different rolls for FOX CTD fork and RockShox DNA 3 fork
(SCOTT Article number: 230097)
- FOX CTD with different rolls for FOX CTD fork and RockShox DNA 3 fork
(SCOTT Article number: 230098)
Please kindly note that the cable roll of a RockShox DNA3 or FOX CTD fork-lever
is not interchangeable with the regular rolls of 2 step forks. You need to use
another lever!
For more details please contact your authorized SCOTT dealer.
To change the rolls to match another fork brand pls follow the drawings below:
ROLL FORK UNMOUNTING
ROLL FORK MOUNTING
08
GENIUS LT | BIKE OWNER'S MANUAL 2015

ASSEMBLY OF THE REMOTE CABLE

IMPORTANT!
Please make sure the lockout of SRAM/RockShox or FOX fork is activated after
transport correctly. Therefore please compress fork 5-10 times before following the
manual on remote cable installation and adjustment.
The lever should show on the downside of the cable roll the brand name of the fork
you are going to use. Please do not try to use a RockShox roll with a FOX fork or
vice versa.
1. To assemble the cable please bring
the lever into the Descent Mode,
push the cable into the lever-
eyelet as shown on drawing below,
push it through the pre-cut cable
housing and fix it at the assembly
unit on top of the right side of the
fork crown.
2. Fix the cable with the 2mm allen screw on the barrel
adjuster on the fork crown with a tightening torque of
0.9Nm/8 lb/in, cut the cable and secure it with a cable
end-cap. Please refer for this action also to the manual
of SRAM/RockShox or FOX attached to the bike.
TIP:
To check for accurate cable tension, please try to move the plastic end cap of the
cable housing at the barrel adjuster on the remote lever. There should be "no-play"
between cap and barrel adjuster. In case of "play" please turn the barrel adjuster
clockwise until "no-play".
BIKE OWNER'S MANUAL 2015 |
09
GENIUS LT