Related Manuals for Scott 2013 Genius LT
Summary of Contents for Scott 2013 Genius LT
- Page 1 GENIUS LT SCOTT 2013 BIKE OWNERS MANUAL SCOTT SPORTS SA | 17 RTE DU CROCHET | 1762 GIVISIEZ | SWITZERLAND © 2011 SCOTT SPORTS SA, ALL RIGHTS RESERVED | SCOTT-SPORTS.COM...
-
Page 2: Table Of Contents
Scott Smart Cable Routing ........ -
Page 3: Genius Lt Concept
Genius LT is a new step on All Mountain Bikes, redefining this category of bikes with a maximum travel of 185mm but yet good in uphill sections. Scott’s focus was not only on lightweight but also on a durable frame with an innovative suspension technology in combination with an optimized kinematics of the rear swingarm. -
Page 4: Technical Data Genius Lt
4 x 6802/ 2 x 61800/ 2 x 6803 Chainguide Alloy frame: ISCG 05, carbon frame: with adapter ISCG Effect of Changing Head Angle Seat Angle BB Offset Standover BB Height from Height LOW to HIGH ° ° inches inches inches 0.7° 0.7° 0.04 BIKE OWNERS MANUAL scott-sports.com... -
Page 5: Twinloc Remote Control Lever
Information and data contained in this document is confidential and proprietary to SCOTT SPORTS SA. BIKE cable-adap Copying, using or disclosing such information and data without written permission of SCOTT SPORTS SA is prohibited. Shock cable tensien screw SHOCK CABLE TENSION SCREW... -
Page 6: Assembly Of The Remote Cable
*** g BIKE twinloc-rocks-cable-ass.asm 10/06/2009 1 / 1 Copying, using or disclosing such information and data without written SCOTT SPORTS SA permission of SCOTT SPORTS SA is prohibited. Route du Crochet 17 CABLE Scale Material Projection 1762 Givisiez assembLy of the remote cabLe... -
Page 7: Equalizer 3 Shock And Twinloc Remote Control Lever
3 shock and tWinLoc remote controL Lever The heart of the TC-System is the new developed and innovative Scott Equalizer 3 Shock made by DT Swiss, offering three functions which make this system possible. In the drawing of the shock and remote lever, shown below, you will see the parts By using the TWINLOC remote lever you can chose following functions on the rear indicated with numbers which will be used in the manual for the adjustment and set-up. -
Page 8: Basic Set-Up Of The Twinloc Remote Control
1.5 mm allen key insert a new cable via lever hole and cable housing and push it into the shock as shown. remove the end cap of the cable with pliers BIKE OWNERS MANUAL scott-sports.com... - Page 9 Rider weight of 110 kgs/243 lbs incl. riding gear and load. on the cable until it touches the cable sled, fix it by squeezing it with pliers and cut the cable just below the cap. Keep 35mm cable length from the edge of the cable sled. BIKE OWNERS MANUAL scott-sports.com...
-
Page 10: Recommended Tools For The Shock Set-Up
To adjust the air pressure of the air chamber of the Scott Equalizer 2 Shock please refer removing the pump from the shock valve, this will result in an exact air pressure. -
Page 11: Set-Up Of Rebound Equalizer 3 Shock
- If it bounces more than 3 times the rebound is too fast. Turn BOTh screws 1-2 “clicks” clockwise - If it does not bounce the rebound is too slow. Turn BOTh screws 1-2 “clicks” counter clockwise. BIKE OWNERS MANUAL scott-sports.com... - Page 12 Please make sure that both rebound wheels show the same number below the arrow Note that you have to mount the Scott Equalizer 3 Shock always as shown underneath. on the shock body. Mounting the rear shock in a different position can cause severe damages to the frame, the linkage levers and the rear shock.
-
Page 13: Set-Up Of Other Shock Models
On Genius LT you will find a Shimano E-type front derailleur but fixed directly on the scott strongly recommends using only the scott equalizer 3 shock with the swingarm without the plate that is fixed normally between the bottom bracket bearing... -
Page 14: Chainguide
The Carbon as well as the alloy frames of Genius LT can be fitted with ISCG chainguide systems. A set of all spare parts for this action can be ordered via the Scott distribution with 219570 Chainguide ISCG Adaptor Set Genius LT... -
Page 15: Headset Options
Genius LT features a tapered headset and fork steerer system to match with semi- The direct and straight cable system on all our full suspension models allows Smart integrated headsets of the “50-61”mm range. -
Page 16: Cable Housing Length
219568 Brake Mount Adapt.Spacers 4mm f/185mm seatcLamp Please make sure only to use the original seatclamp of Scott Genius LT with a diameter of 34.9mm. This part can also be ordered as a spare part via the Scott distribution with 219569 Seatclamp 34.9mm QR Genius LT 2011... -
Page 17: Ids 2 / Replaceable Dropout
It is also possible to use 180mm rotors. To do so, please remove the 2 washers with a laser logo of “185mm” and fix the calliper directly on the PM on the seatstay. All Genius LT bikes feature the new IDS 2 System of Scott. 3 different version of IDS 2 are available,... -
Page 18: Front Fork Set-Up/ Change Of Front Fork
We recommend the same for the chain also. you can also order the right side RD hanger separately via the Scott distribution in case you need this to repair a damage on the RD hanger. -
Page 19: Warranty
5 years for the frame shall be reduced to 3 years. Costs for maintenance and service have to be born by the owner of the SCOTT bike. Shock Nr................