Basic Set-Up Of The Twinloc Remote Control Of Fox Ctd Shock; Recommended Tools For The Shock Set-Up - Scott Genius LT Owner's Manual

3. tighten the cable and fix the cablefixing
screw (S7) by turning it clockwise with
a 2mm allen key and a max. tightening
torque of 1.6Nm.
4. Check that the
handlebar lever
is in the traction
position. Refer to the
diagram below.
5. cut the cable approx. 20mm away from
the remote wheel. Fix it by squeezing it
with pliers.
6. push a cable end-cap on the cable until
it touches the end of the cable. Fix it by
squeezing it with pliers.
12
GENIUS LT | BIKE OWNER'S MANUAL 2015
BASIC SET-UP OF THE TWINLOC REMOTE CONTROL OF
FOX CTD SHOCK
The assembly of the remote cable and the setup of the FOX CTD rear shock is very
similar to the abovementioned assembly and setup of the FOX Nude.
For more details on the FOX CTD please follow the details shown in the manuals of
FOX attached to this bike

RECOMMENDED TOOLS FOR THE SHOCK SET-UP

For the set-up of the shock we recommend to use a shock pump with a scale up
to 20 bars/300 psi with a special air valve connector preventing from air getting
away while removing the pump from the shock valve, this will result in an exact air
pressure.
Please note that air will flow into the hose and indicator when counterchecking the
air pressure, so you have to set up again the recommended pressure after this action.
Make sure to balance at least this air loss when you make a check of the air pressure
of the shock. Please also note that the indicators of shock pumps have a tolerance of
max. 10%.
BIKE OWNER'S MANUAL 2015 |
13
GENIUS LT