Assembly Of The Remote Cable - Scott Genius LT Series User Manual

SCOTT offers 2 different TWINLOC levers with following fork/rear shock combinations:
- FOX Nude with different rolls for FOX CTD fork and RockShox DNA 3 fork
(SCOTT Article number: 230097)
- FOX CTD with different rolls for FOX CTD fork and RockShox DNA 3 fork (SCOTT Article
number: 230098)
Please kindly note that the cable roll of a RockShox DNA3 or FOX CTD fork-lever is not
interchangeable with the regular rolls of 2 step forks. You need to use another lever!
For more details please contact your authorized SCOTT dealer.
To change the rolls to match another fork brand pls follow the drawings below:
ROLL FORK UNMOUNTING
ROLL FORK MOUNTING
| 08 ENGLISH
GENIUS LT | 2016 BIKE USER MANUAL
•

ASSEMBLY OF THE REMOTE CABLE

IMPORTANT!
Please make sure the lockout of SRAM/RockShox or FOX fork is activated after transport
correctly. Therefore please compress fork 5-10 times before following the manual on remote
cable installation and adjustment.
The lever should show on the downside of the cable roll the brand name of the fork you are
going to use. Please do not try to use a RockShox roll with a FOX fork or vice versa.
1. To assemble the cable please bring the
lever into the Descent Mode, push the
cable into the lever-eyelet as shown
on drawing below, push it through the
pre-cut cable housing and fix it at the
assembly unit on top of the right side of
the fork crown.
2. Fix the cable with the 2mm allen screw on the barrel adjuster
on the fork crown with a tightening torque of 0.9Nm/8 lb/in,
cut the cable and secure it with a cable end-cap. Please refer
for this action also to the manual of SRAM/RockShox or FOX
attached to the bike.
TIP:
To check for accurate cable tension, please try to move the plastic end cap of the cable
housing at the barrel adjuster on the remote lever. There should be "no-play" between cap
and barrel adjuster. In case of "play" please turn the barrel adjuster clockwise until "no-play".
2016 BIKE USER MANUAL | GENIUS LT
ENGLISH 09 |