Assembly Of The Remote Cable - Scott Genius LT Owner's Manual

SCOTT offers 2 different TWINLOC levers with following fork/rear shock
combinations:
- FOX Nude with different rolls for FOX CTD fork and RockShox DNA 3 fork (SCOTT
Article number: 230097)
- FOX CTD with different rolls for FOX CTD fork and RockShox DNA 3 fork (SCOTT
Article number: 230098)
Please kindly note that the cable roll of a RockShox DNA3 or FOX CTD
fork-lever is not interchangeable with the regular rolls of 2 step forks. You
need to use another lever!
For more details please contact your authorized SCOTT dealer.
To change the rolls to match another fork brand pls follow the drawings
below:
8
BIKE OWNER'S MANUAL

ASSEMBLY OF THE REMOTE CABLE

IMPORTANT:
Please make sure the lockout of SRAM/RockShox or FOX fork is activated
after transport correctly. Therefore please compress fork 5-10 times before
following the manual on remote cable installation and adjustment.
The lever should show on the downside of the cable roll the brand name of
the fork you are going to use. Please do not try to use a RockShox roll with a
FOX fork or vice versa.
1. To assemble the cable please bring the lever into the Descent Mode, push
the cable into the lever-eyelet as shown on drawing below, push it through
the pre-cut cable housing and fix it at the assembly unit on top of the right
side of the fork crown.
2. Fix the cable with the 2mm allen screw on the barrel adjuster on the fork
crown with a tightening torque of 0.9Nm/8 lb/in, cut the cable and secure
it with a cable end-cap. Please refer for this action also to the manual of
SRAM/RockShox or FOX attached to the bike.
TIP:
To check for accurate cable tension,
please try to move the plastic end
cap of the cable housing at the
barrel adjuster on the remote lever.
There should be "no-play" between
cap and barrel adjuster. In case of
"play" please turn the barrel adjuster
clockwise until "no-play".
scott-sports.com
9