Real Time Operation - Queclink GL100 User Manual

GL100 User manual
Step_5: Select the connection which enables Synchronization ACK mechanism. In the current
version only UDP is supported and choice 1, 4 is reserved for future use.
1: TCP packet. Not supported at present.
2: UDP packet.
4: SMS PDU. Not supported at present.
Step_6: Click "Select All" button to select all the messages if necessary.
Click "Deselect All" button to deselect all the messages if necessary.
Step_7: Click the "Send" button; download the parameters of GTACK to GL100.

4.4.7. Real Time Operation

Step_1
Step_3
Step_2
Step_1: Select "Enable This Function", after that the parameters of GTRTO can be changed and
the "Send" button is enabled.
Step_2: When "Enable This Function" is selected, the command message which shall be sent to
Step_3: Select "Command Option":
TRACGL100UM002
message is sent through the connection specified by "Ack Type", GL100 will wait for
the Synchronization ACK message. Otherwise, GL100 won't wait for the
Synchronization ACK message. Please refer to "GL100 @Track Air Interface Protocol"
for detail.
GL100 will be generated based on input and displayed here. Please note this command
message can also be sent to GL100 through SMS or GPRS.
Choice 0-8, A-B is just for a dedicated action without any parameter. For the
definition, please refer to the following.
0: Get the latest time of successful GPS fixing.
1: Require the terminal to report the current position immediately
2: Get the current configuration of the terminal.
3: Reboot the terminal.
Step_4
- 20 -