Msds For Silicone Oil - Tektronix PHASER 840 Advanced Features And Troubleshooting Manual

10
Regulatory Information and Specifications

MSDS for Silicone Oil

Section 1 – Product Identification
Trade Names:
Tektronix Silicone Intermediate Transfer Layer Fluid, impregnated into printer's maintenance roller.
Tektronix part number: 401-0777-00 (original maintenance roller)
Tektronix part number: 016-1727-00 (replacement maintenance kit)
®
Product Use: Tektronix Phaser 840 color printer
Section 2 – Information On Ingredients
Ingredients
Tektronix Silicone Intermediate Transfer Layer Fluid is a proprietary blend of silicone oils. SpeciÞc identities of
components, and their percentage composition, are withheld as a trade secret.
Section 3 – Hazards Identification
ROUTES OF EXPOSURE: Skin, eyes
POTENTIAL HEALTH EFFECTS: Health effects from this product are expected to be negligible, when product is used
as intended.
Immediate Effects:
Inhalation: Not an expected route of entry
Skin: May cause mild irritation.
Eye: May cause mild irritation.
Ingestion: Not an expected route of exposure.
Chronic Effects: None known or expected.
SIGNS AND SYMPTOMS OF EXPOSURE: Mild skin or eye irritation.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None known.
Section 4 – First Aid Measures
Inhalation: Not a route of exposure for this product.
Eyes: Flush thoroughly with water. Seek medical attention if symptoms occur.
Skin: Wash thoroughly with soap and water. Seek medical attention if symptoms of irritation occur.
Ingestion: Not a route of exposure for this product.
Section 5 – Fire Fighting Measures
Flammable Properties:
Flash Point: No data.
FIRE FIGHTING INSTRUCTIONS: As for any fire, wear self-contained breathing apparatus, pressure demand,
MSHA/NIOSH approved, and protective gear.
Fire & Explosion Hazards: During a fire, irritating and toxic substances may be generated by thermal decomposition or
combustion. No unusual fire hazards expected.
2
Extinguishing media: All extinguishing agents classified as B and C are effective, including dry powder(s), CO , and
halon.
Section 6 – Accidental Release Measures
Spill Or Leak: Fluid is impregnated into maintenance roller. Small amounts (i.e., drops) may result from normal
handling. Absorb and place in an appropriate disposal container. Clean spills thoroughly because residue can be
slippery.
Section 7 – Handling And Storage
Handling: Wash hands with soap and water after contact. Clean spills per SECTION 6.
Storage: No special requirements.
Section 8 – Exposure Control – Personal Protection
No special protection indicated when used as intended.
Advanced Features and Troubleshooting Manual 125