decorflame MM650C-38ACH Instruction Manual page 3

MANtEl ASSEMBlY:
CAUTION: Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the screws until all panels are assembled.
NOTE: Each plastic connector is pre-assembled (pre-drilled) on the specific panels with
2 screws. If the screw(s) do not fit during assembly, loosen the 2 (pre-drilled) screws to adjust
the plastic connector until the screws are able to be installed. Tighten all screws once all panels
are assembled.
Step 1: Attach all plastic connector [T] to the panels [C, H, J, K and L] as shown in Fig. A.
(2 pcs screws for each connector)
Step 2: Attach the left small panel [H] to the left front panel [F] with 2 screws (Q). Attach the
right small panel [J] to the right front panel [G] with 2 screws (Q). See fig. B
Fig. A BACk
Fig. B BACk
Step 3: Attach the left side panel [K] to the left front panel [F] with 3 screws (Q). Attach the
right side panel [L] to the right front panel [G] with 3 screws (Q). See fig. C
Step 4: Attach the left [K, F, H] and right [L, G, J] side panels to the base panel [B] using 4
screws (Q) (2 screws on each side). See Fig. D
3
Fig. C BACk
Fig. D BACk