Replacing The Light Bulbs - decorflame MM650C-38ACH Instruction Manual

rEPlAciNG tHE liGHt BUlBS

REPLACING THE
LIGHT BULBS
Step 1: Remove 4 screws on the back
cover of the unit.
You will nd 1 X E12 40W Type B-10
bulbs under log-set bed.
Step 3: Loosen and remove burnt
out bulb(s) and replace with
new bulb(s).
Step 4: Close the rear cover and secure
with the 4 screws.
Step 5: Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly – such
as if the panels cannot be installed with the plastic connector – try to solve by one
of the following methods.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Phillips screwdriver, safety goggles and gloves (if necessary).
wARNING: wEAR GOGGlES BEFORE yOU START DRIllING.
OPTION 1:
Use the spare nuts, screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in
Fig. A.
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on
the mantel. Each plastic connector needs 3 holes. See Fig. B.
7
Fig. A