Winding The Bobbin - JUKI HZL-70 series Instruction Manual

Winding the bobbin

1. Place the thread and spool
2. Snap the thread into the
3. Wind the thread clockwise
4. Place the thread end through
5. Push the bobbin to right.
6. Hold the thread tail securely in
7. Press on the foot control or the
8. After the bobbin has wound a
9. Cut the thread and then
- When the bobbin winder switch
- If you find the bobbin winding
14
cap onto the spool pin.
For smaller spools of thread,
place spool cap with the small
side next to the spool or use
the small spool cap.
thread guide.
around the bobbin winder
tension discs.
one of the inner holes in the
bobbin as illustrated and place
empty bobbin on the spindle.
When the bobbin winder
spindle is pushed to the right,
the number display will blink on
and off while displaying "
It will disappear when the
bobbin winder spindle is
pushed to the left, which is the
"sewing position".
one hand.
Start/stop button to start
winding the bobbin.
few turns stop the machine
and cut the thread near the
hole of the bobbin. Continue
filling the bobbin until it is full.
Once the spool is full, it rotates
slowly. Release the pedal or
stop the machine. Push the
bobbin winder spindle to left.
remove the bobbin.
Note:
is placed on the right "bobbin
winding position", the buttons
will not work. To start sewing,
push the bobbin winder switch
to the left "sewing position".
the thread unevenly, you can
adjust the height of the winder
tension disc (3) to improve it.
SP
".