Threading The Upper Thread - JUKI HZL-70 series Instruction Manual

6
5
7
Threading the upper
thread
It is important to carry out the
threading correctly as by not
doing so several sewing
problems could result.
Start by raising the needle to
its highest point, and also
raise the presser foot to
release the tension discs.
1. Place the thread and
2. Draw the thread from the
3. Guide the thread around the
4. Thread the tension module
5. Then, down and around the
6. At the top of this movement,
7. Pass the thread behind the
16
Note:
spool
cap onto the spool pin.
For smaller spools of thread,
place spool cap with the
small side next to the spool
or use the small spool cap
spool through the upper
thread guide.
thread guide pulling the
thread through the pre-
tension spring as illustrated.
by passing the thread
between the silver discs.
check spring holder.
pass the thread from right to
the left through the slotted
eye of the take-up lever and
then downwards again.
flat, horizontal thread guide.
Guide the thread through
the wire loop.
Pull the end of the thread
through the needle from
front to rear, and pull out
about 10 cm of thread.
Use the needle threader to
thread the needle. (On the
next page.)
.