Operation - Ozito OZCS1200WA Instruction Manual

TOOL OPERATION
Fitting the Blade
! ! Warning! Disconnect the plug from the power source before assembling,
making any adjustments or changing accessories. Such preventive safety
measures reduce the risk of starting the tool accidentally.
1. Press the spindle lock button (6) and using the allen key (23) turn until spindle
lock button (6) engages. Whilst depressing the spindle lock button (6), turn the
allen key (23) counter-clockwise and remove blade bolt (15) and outer blade
flange (13).
2. Ensure blade flanges and bolt is clean of sawdust, grease, etc.
3. Retract the lower blade guard (12) all the way up into the upper blade guard
(5). While retracting the lower blade guard (12), check operation and condition
of the lower guard spring.
4. Make sure the saw teeth and arrow on the blade (18) point in the same
direction as the arrow on the upper blade guard (5).
5. Slide blade (18) through slot in the baseplate (16) and mount it against the
inner blade flange (14) on the shaft. Make sure the large diameter of the blade
flanges lay flush against the blade.
6. Fit outer blade flange (13). First tighten blade bolt (15) finger tight. Engage
spindle lock button (6). Whilst depressing the spindle lock button (6), tighten
blade bolt (15) firmly with the allen key (23) supplied.
7. Before connecting the saw to a power source, ensure that:
• the spindle lock button (6) is released
• the blade (18) rotates freely
• the lower blade guard (12) operates correctly
Note: Do not use allen keys with longer handles, since it may lead to over
tightening of the blade bolt (15).
Depth Adjustment
Disconnect plug from power source. Loosen the depth adjustment knob (19). Hold
the baseplate (16) down with one hand and raise or lower the saw by the soft grip
handle (21). Tighten depth adjust knob (19) at the depth setting desired. Check
desired depth.
To obtain minimum splintering while operating, ensure that no more than one
tooth protrudes through the timber.
90º Cutting Angle Check
Disconnect plug from power source. Set baseplate (16) to maximum depth of cut
setting. Loosen bevel adjustment knob (10), set to 0º on bevel scale (7), retighten
bevel adjustment knob (10) and check for 90º angle between the blade (18) and
bottom plane of the baseplate (16), with a square.
9