100
BDL4675XU LCD
7.9 Plastics Flammability
•
All Plastics to be Flame Retardant UL 94-V0 or Better (if Display weighs less than 18kg;
UL94-V0 is OK).
•
Base / Pedestal to be Flame Retardant UL 94-HB.
•
All major plastic parts (bezel, back cover, base) need to be molded from same resin. Base /
Pedestal otherwise specified.
No plastic parts
7.10 Texture/Glossing of Housing
•
The texture area and texture no should follow Philips make-up sheet.
•
The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
•
Detail document for texture refer to UN-D249.
•
The gloss value of texture area < = 20 gloss units.
No plastic parts
7.11 Base Tilt / Swivel Range
•
Tilt -
•
Swivel Range -
•
Base detach -
•
Tip over -
7.12 Movement of Unit with Base
•
Base must have non-marring, non-staining feet.
•
Unit must tilt up and down with no "Stick / Slip".
•
Base must provide sufficient friction to hold unit in desired position after adjusting tilt.
7.13 Wall Mount Method
•
VESA in back-cover.
General Product Specification
N.A. (per commercial spec request)
0°
Should be directly disassembled from main body, so as for easy
install the Display to wall mount.
15° minimum in worst case, base dimension designed so that ID
and tip over requirements can be met.