Mechanical Characteristics; Cosmetic; Mechanical Data Files; Location Of Philips Logo - Philips 226V3LSB/00 Service Manual

Meridian 3
90

MECHANICAL CHARACTERISTICS

Cosmetic -

Philips ID

Mechanical data files -

ProE files required

Location of Philips logo -

Per Philips make-up sheet

Gap between panel and front bezel

15"~19": <0.8mm, 19"W:<1.0mm, 20W~23"W: <1.2mm, 24"W: <1.4mm

Location of Control icons -

Location of Control icons -
Per Philips Graphic sheet

Color for resin/paint -

Per Philips make-up sheet

Fire enclosure request

Shielding Cover should fulfill international standard

Resins

 RoHS required
 WEEE required.
 Resin type/selection refer to Project Book Section 7.2 Plastic material.

If paint is used

 RoHS required
 WEEE require
 If new painting type need to implement, refer to UN-D 1235.

Plastic mold tooling

 Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
 Painting to cover up cosmetic defects due to molding is strongly discouraged.
 China RoHS mark requested.

Plastics flammability

 All Plastics to be Flame Retardant UL 94-HB or Better.

Base / Pedestal to be Flame Retardant UL 94-HB.
 All major plastic parts (bezel, back cover) need to be molded from same resin.

Plastic resin type selection should be referred to "plastic-Philips Pool monitor".