Plastics Flammability; Texture/Glossing Of Housing; Tilt And Swivel Base - Philips 192E1SB/70 Service Manual

5.11 Plastics flammability

All Plastics to be Flame Retardant UL 94-HB.
Base / Rear to be Flame Retardant UL 94-HB
All major plastic parts (bezel, back cover) need to be molded from same resin. Plastic resin type selection
should be referred to "TY R83-2-9002-1".
Plastic resin type selection should be referred to "plastic-Philips pool monitor".

5.12 Texture/Glossing of housing

The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
> = 80 gloss units

5.13 Tilt and swivel base

Tilt angle : -5 +2/- 0
+20 +0/- 2 (backward)
Tilt for left and right:
A-B
Black side and cut side
L
Gap between bezel and rear cover
Step between bezel and rear cover
"Wobble", "Twist", etc (front to back or side to side)
Whole monitor set shall retain stability within a short time after the applied external force disappears.
20NT , 6secs Max.
5.14 Kensington Lock
Must meet Kensington_slot.spec "TYE-M0004".
MMD request metal plate in Kinsington hole.
5.15 Label
Carton label should follow Philips requirement.
Regulatory label follow Philips requirement
(forward)
4.0mm
U
D
0.4 mm
Left, right and top: 0.3mm
back to stable.
A
1. Visual area
H
V U-D
R
2. Black side on the left and right is
symmetrical, not cut side.
Bottom and corner: 0.5mm
Meridian 1
B
L-R 0.8~1.0mm
0.8~1.0mm
81