Plastic Mold Tooling; Plastics Flammability; Texture/Glossing Of Housing - Philips 191V2SB/01 Service Manual

5.10

Plastic mold tooling

• Tooling to be designed to minimize cosmetic defects induced by molding process (sink,
blush, weld lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
• Painting to cover up cosmetic defects due to molding is strongly discouraged.
• China RoHS mark requested.
5.11

Plastics flammability

• All Plastics to be Flame Retardant UL 94-HB.
• Base / Rear to be Flame Retardant UL 94-HB.
• All major plastic parts (bezel, back cover) need to be molded from same resin.
• Plastic resin type selection should be referred to "plastic-Philips Pool monitor".

5.12 Texture/Glossing of housing

• The texture area and texture no should follow Philips make-up sheet.
• The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
•
• Detail document for texture refer to "UN-D249", "UN-D 600".
• > = 80 gloss units
Rev :
0.1
Date :
2009/07/15
191V2
Type :
Brand :
PHILIPS
18.5" LCD Monitor
Page :
17 of 26