Installing A Network Adapter Card - Allied Telesis AT-2400T Installation Manual

Installing a Network Adapter Card

This section explains how to install a network adapter card in most PC-
compatible computers.
To install the adapter card, perform the following procedure:
1. Shutdown your PC and disconnect the power cord from the outlet.
2. Remove the PC's cover by removing the screws from the chassis and
gently sliding off the cover. See Figure 1.
Figure 1 Removing the PC Cover
3. Select an empty, non-shared PCI slot and remove the faceplate.
Keep the faceplate in a safe place. You may need it for future use.
See Figure 2.
Figure 2 Removing the Faceplate From PCI Slot
Note
If you cannot locate or know how to find an PCI slot, refer to the
documentation that came with your PC.
Network Adapter Card Installation Guide
17