Wake-On-Lan; Bootprom - Allied Telesis AT-2400T Installation Manual

Troubleshooting

Wake-on-LAN

BootPROM

112
Check to be sure that the operating specifications on the remote
Ethernet hub or switch (e.g., operating speed and duplex mode)
are compatible with the operating characteristics of the adapter
card. For example, you cannot connect the fiber optic port on an
AT-2450FTX, which has a fixed operating speed of 10 Mbps speed,
to a port on an Ethernet switch which has a fixed operating speed
of 100 Mbps.
If you are using the AT-2450FTX, AT-2700FTX, AT-2701, or
AT-2745FX adapter card, only one port can be connected to the
network at a time.
Try connecting the fiber optic cable to a different port on the
Ethernet hub or switch.
If the above troubleshooting guidelines do not resolve the problem, run
the diagnostics utility. For instructions, refer to
page 113.
The Wake-on-LAN feature is only available on the AT-2450, AT-2500,
AT-2501, AT-2700, and AT-2701 Series adapter cards. Below are
troubleshooting guidelines for the Wake-on-LAN feature:
Refer to your computer's documentation to determine if your
computer supports Wake-on-LAN. This feature is not supported
on all computers.
Determine the type of power system your computer has. Refer to
your computer's documentation for instructions. If your computer
has an Advanced Configuration and Power Interface (ACPI), you
must connect a special cable between the Wake-on-LAN
connector on the adapter card and the computer's motherboard.
(If the computer uses an Advanced Power Management system,
this wire is not necessary.) You must connect the wire when you
install the adapter card in the computer.
Check to be sure that your network management program can
send out Magic Packets based on the Wake-on-LAN technology.
Below is the troubleshooting guideline for the BootPROM feature:
Check to be sure that the BootPROM chip has been installed
correctly.
Running Diagnostics on