Running Diagnostics - Allied Telesis AT-2400T Installation Manual

Running Diagnostics

The diagnostics utility is useful for viewing or changing configurations,
running diagnotics and viewing information files. This utility is located
on the CardAssistant CD or the driver installation disk.
To run diagnostics, perform the following procedure:
1. If ON, power OFF your computer and reboot into DOS mode.
Note
For Windows 98 and Me, reboot your computer with the Windows
Startup disk. The diagnostics file must be run in DOS mode.
2. Insert the CardAssistant CD or the driver installation disk into the
appropriate drive.
Note
If you are using the CardAssistant CD and your computer launches
the web browser, close or minimize the web browser window.
3. At the DOS prompt, launch the diagnostic utility for the adapter card
that you purchased.
The location of the diagnostic files on the CardAssistant CD are:
Adapter Card
AT-2400T, AT-2400BT
AT-2450FXT
AT-2500, AT-2500TX,
AT-2501
AT-2700TX, AT-2700FX,
AT-2700FTX, AT-2745FX
AT-2701
AT-2915T, AT-2930
For example, if you want to run diagnostics for an AT-2500 Series
adapter card and the CD is mapped to drive D, you would enter:
D:\drivers\at2500\diag\setup25.exe
If you are using a driver installation disk, the diagnostic files are
stored in the root directory of the disk.
Network Adapter Card Installation Guide
Diagnostic Location and File
\drivers\at2400\diag\set2400.exe
\drivers\at24_27\diag\diag.exe
\drivers\at2500\diag\setup25.exe
\drivers\at24_27\diag\diag.exe
\drivers\at2701\diag\diag.exe
\drivers\at29xx\diag29.exe
113