Running At-Setup - Allied Telesis AT-2400T Installation Manual

AT-Setup for Windows 98, 2000, Me, or XP

Running AT-Setup

24
To run AT-Setup to install a new driver, perform the following procedure:
1. Insert the CardAssistant CD into your CD-ROM drive. If you are using
a driver installation disk, proceed to
Note
For instructions on how to create a driver installation disk, refer to
Creating a Driver Installation Disk
The CardAssistant Main Menu shown in Figure 5 is displayed. If this
menu is not displayed, double-click on the My Computer icon, then
double-click on the Allied Telesyn CD-ROM icon.
Figure 5 CardAssistant CD Main Menu
2. From the Driver Setup drop-down menu, select the adapter card
that you purchased.
Step 7.
on page 33.