Windows 95 - Allied Telesis AT-2400T Installation Manual

Manually Installing a Network Adapter Driver

Windows 95

36
This section contains the procedure for manually installing a network
adapter driver in a Window 95 operating system.
Note
Please review the
performing the following procedure.
1. Shutdown Windows 95 and power OFF the computer.
2. Install the network adapter card. Refer to
Adapter Card on page 17 and the documentation that came with
your computer for instructions.
3. Power ON the computer.
Note
You should have the Windows 95 CD or floppy disk(s) available. You
may be prompted to copy support files for networking.
Windows 95 will search the computer for any new hardware. Once it
detects a new adapter card, it will display a prompt notifying you
that it has found a new adapter card and that the adapter driver
needs to be installed.
4. Insert the CardAssistant CD or the driver installation disk into the
appropriate drive.
Note
If you are using the CardAssistant CD and your computer launches
the web browser, close or minimize the web browser window.
5. Type in the letter name and path to the adapter driver, then select
Return.
For example, if you are installing an adapter driver for an AT-2500
Series adapter and the CD is mapped to drive D, you would enter:
D:\drivers\at2500.
Installation Guidelines on page 32 before
Installing a Network