D-Link xstack DGS-3612G Instruction Manual page 318

xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
DGS-3612G:4#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK!!!
SIM Config Success !!!
Success.
DGS-3612G:4#
To delete a member:
DGS-3612G:4#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK!!!
SIM Config Success!!!
Success.
DGS-3612G:4#
config sim
Purpose
Syntax
Description
Parameters
Restrictions
To change the time interval of the discovery protocol:
Used to configure role parameters for the SIM protocol on the Switch.
config sim [[commander {group_name <groupname 64>} |
candidate] | dp_interval <sec 30-90> | hold_time <sec 100-255>]}
This command is used to configure parameters of switches of the SIM.
commander – Use this parameter to configure the commander switch(CS)
for the following parameters:
group_name <groupname 64> - Used to update the name of the
group. Enter an alphanumeric string of up to 64 characters to
rename the SIM group.
dp_interval <30-90> – The user may set the discovery protocol
interval, in seconds that the Switch will send out discovery
packets. Returning information to the CS will include information
about other switches connected to it. (Ex. MS, CaS). The user
may set the dp_interval from 30 to 90 seconds.
hold time <sec 100-255> – Using this parameter, the user may
set the time, in seconds, the CS will hold information sent to it
from other switches, utilizing the discovery interval protocol. The
user may set the hold time from 100 to 255 seconds.
candidate – Used to change the role of a CS (commander) to a CaS
(candidate).
dp_interval <30-90> – The user may set the discovery protocol
interval, in seconds that the Switch will send out discovery
packets. Returning information to the CS will include information
about other switches connected to it. (Ex. MS, CaS). The user
may set the dp_interval from 30 to 90 seconds.
hold time <100-255> – Using this parameter, the user may set
the time, in seconds, the Switch will hold information sent to it
from other switches, utilizing the discovery interval protocol. The
user may set the hold time from 100 to 300 seconds.
Only administrator-level users can issue this command.
315