D-Link xstack DGS-3612G Instruction Manual page 248

enable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To enable PIM as previously configured on the Switch:
DGS-3612G:4#enable pim
Command: enable pim
Success.
DGS-3612G:4#
disable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To disable PIM on the Switch:
DGS-3612G:4#disable pim
Command: disable pim
Success.
DGS-3612G:4#
show pim neighbor
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to enable PIM function on the Switch.
enable pim
This command will enable PIM for the Switch. PIM settings must first be
configured for specific IP interfaces using the config pim command.
None.
Only administrator-level users can use this command.
Used to disable PIM function on the Switch.
disable pim
This command will disable PIM for the Switch. Any previously
configured PIM settings will remain unchanged and may be enabled at
a later time with the enable pim command.
None.
Only administrator-level users can use this command.
Used to display PIM neighbor router table entries.
show pim neighbor {ipif <ipif_name 12> | ipaddress
<network_address>}
This command will list current entries in the PIM neighbor table for a
specified IP interface or destination router IP address.
ipif <ipif_name 12> – The name of an IP interface for which to view the
PIM neighbor router table.
ipaddress <network_address> - The IP address and netmask of the
destination routing device for which to view the neighbor router table.
The user can specify the IP address and netmask information using the
traditional format or the CIDR format. For example,
10.1.2.3/255.255.0.0 or 10.2.3.4/16.
245