D-Link xstack DGS-3612G Instruction Manual page 259

config ospf area
Restrictions
Usage example
To configure an OSPF area's settings:
DGS-3612G:4#config ospf area 10.48.74.122 type stub stub_summary enable metric 1
Command: config ospf area 10.48.74.122 type stub stub_summary enable metric 1
Success.
DGS-3612G:4#
show ospf area
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To display an OSPF area's settings:
DGS-3612G:4#show ospf area
Command: show ospf area
Area ID
--------------
0.0.0.0
10.48.74.122
244.0.0.6
Total Entries: 3
DGS-3612G:4#
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
configured here as a stub area.
•
nssa – Choosing this parameter will define the OSPF area
configured here as an NSSA (Not So Stubby Area) area.
stub_summary [enable | disable] − Allows the OSPF area import of
LSA advertisements to be enabled or disabled.
metric <value 0-65535> − The OSPF area stub default cost.
Only administrator-level users can issue this command.
Used to display an OSPF area's configuration.
show ospf area {<area_id>}
This command will display the current OSPF area configuration.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
None.
Type Stub Import Summary LSA
------------- ------------------------------------
Normal None
Stub Enabled
NSSA Enabled
•
translate [enable | disable] – Enable this parameter to
translate Type-7 LSAs into Type-5 LSAs, so that they
can be distributed outside of the NSSA. The default is
Disabled. This field can only be configured if nssa is
chosen in the type field.
256
Stub Default Cost Translate
------------------- ---------------
None None
Enabled None
5 Enabled