D-Link xstack DGS-3612G Instruction Manual page 121

config link_aggregation algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3612G:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3612G:4#
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the link aggregation algorithm.
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest | ip_source | ip_destination | ip_source_dest]
This command configures the part of the packet examined by the Switch
when selecting the egress port for transmitting load-sharing data. This
feature is only available using the address-based load-sharing algorithm.
mac_source − Indicates that the Switch should examine the source MAC
address.
mac_destination − Indicates that the Switch should examine the
destination MAC address.
mac_source_dest − Indicates that the Switch should examine the source
and destination MAC addresses
ip_source − Indicates that the Switch should examine the source IP
address.
ip_destination − Indicates that the Switch should examine the destination
IP address.
ip_source_dest − Indicates that the Switch should examine the source
and the destination IP address.
Only administrator-level users can issue this command.
Used to display the current link aggregation configuration on the Switch.
show link_aggregation {group_id <value 1-32> | algorithm}
This command will display the current link aggregation configuration of
the Switch.
<value 1-32> − Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies each
of the groups.
algorithm − Allows you to specify the display of link aggregation by the
algorithm in use by that group.
None.
118