show iproute ipv6
Restrictions
Example usage:
To display the static IPv6 entries in the routing table:
DGS-3612G:4# show iproute ipv6
Command: show iproute ipv6
Routing Table
IPV6 Address/Netmask
--------------------------------
1234::/32
Total Entries: 1
DGS-3612G:4#
create iproute ipv6 default
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add the default static address 1234::5D7F/32, with a metric setting of 1, to the routing table:
DGS-3612G:4#create iproute default 1234::5D7F/32 2D30::AC21 metric 1
Command: create iproute default 1234::5D7F/32 2D30::AC21 metric 1
Success.
DGS-3612G:4#
delete iproute ipv6 default
Purpose
Syntax
Description
Parameters
Restrictions
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
(ipv6address is hexadecimal number, prefix length is decimal number,
for example 1234::5D7F/32).
None.
Used to create IP route entries to the Switch's IP routing table.
create iproute ipv6 default <ipv6addr> {<metric 1-65535>}
This command is used to create a default static IP route entry to the Switch's
IP routing table.
<ipv6addr> − The gateway IPv6 address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
Only administrator-level users can issue this command.
Used to delete a default IPv6 route entry from the Switch's IP routing
table.
delete iproute ipv6 default
This command will delete an existing default entry from the Switch's IP
routing table.
None.
Only administrator-level users can issue this command.
Gateway
Cost
------------------------
--------
2D30::AC21
1
225
Protocol
--------
Static