Hitachi compute blade 500 series Getting Started Manual page 45

Management LAN port configuration is completed.
Repeat step 7 to step 10 as necessary for switch module 1 to 3.
LAN switch module initial configuration
Create new user ID.
Login
1 Start a terminal emulator to the switch module from the system console,
.
and then connect IP address configured at
configuration on page
2 The system administrator's user ID and password have factory default
.
values. Input the following user ID and password to login.
Table 2-4 Factory default setting for the system administrator
Item
User ID
Password
Input <operator> as the user ID, and then press Enter.
Hitachi Compute Blade 500 Series Getting Started Guide
2-14.
Factory default setting
operator
(not set)
Initial setup
Management LAN port
2-21