Hitachi compute blade 500 series Getting Started Manual page 56

Hide thumbs Also See for compute blade 500 series:
Table of Contents

Advertisement

Input <admin> in the login line, and then press Enter.
Input <password>, and then press Enter.
Changing password
Change the password for the admin user ID.
1
Input configure terminal and press Enter to move to global
.
configuration mode.
2
Input username admin password <new password> role admin enable
.
true, and then press Enter.
Logout
1
Input logout, and then press Enter.
.
Fibre Channel switch module initial configuration
This section describes how to configure Brocade 8 Gb/sec Fibre Channel
switch module and Brocade 16 Gb/sec Fibre Channel switch module.
Change the system administrator password, and create a new user ID and
password. For the procedure in detail, see
manuals in Hitachi Compute BladeFibre Channel SwitchAccessory DVD(EN).
Login
1
Start a terminal emulator to the switch module from the system console,
.
and then connect IP address configured at
configuration on page
2
The system administrator's user ID and password have factory default
.
values. Input the following user ID and password to login.
2-32
2-14.
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide
Referenced Documents on page xiv
Management LAN port

Advertisement

Table of Contents
loading

Table of Contents