Hitachi compute blade 500 series Getting Started Manual page 50

Authentication settings for management module
Setup authentication to the user ID created
management module on page
1 Start a web browser on the system console.
.
2 Enter the URL of management module's web console ("https://
.
192.168.0.1/" as the factory default) in the navigation bar.
IP address of management module
URL of Web console
Tip:
•
•
•
2-26
Table 2-5 Factory default settings
Item
The above URL is the default. When you use the default, you can omit
to enter a port number. If you change the IP address of management
module or the port number, enter the URL corresponding to the new
settings.
The format of URL is as below:
http://< IP address>:< port number> or
https://< IP address>:< port number>
The default port number:
- http: 80
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide
inUser ID creation for
2-24.
Factory default
192.168.0.1
https://192.168.0.1