Refi T Window - Valor 1600IN Installation & Owner's Manual

L1 series dv zc two-sided gas fireplace
Hide thumbs Also See for 1600IN:
Table of Contents

Advertisement

Refi t Window
1. To refi t the window, place it in its bottom railing.
Ensure there is no glass or vermiculite
particles in the bottom railing.
Bottom railing
2. Push the top
of the window
frame against
the fi rebox.
3. While you hold it, pull the side levers back into the
window brackets on each side.
Installation
Window frame
Section Views
Valve
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox..
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
QUALIFIED
INSTALLER
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

1600ip

Table of Contents