Table of Contents
Advertisement
ing agents nor polishes should be used. Dry stains can
be removed using a white or light colored cloth with mild
soap and warm water when the material is cool, then
dried immediately. If the stain is hard to remove, use a
white or light colored synthetic scrub pad (not steel wool)
and dry immediately. In case of an accidental spill, soak
up the liquid IMMEDIATELY with a dry cloth and follow
up with a wipe down with a wet cloth.
Clean the barrier screen dusting it with a soft brush.
Clean the fi rebox ceramic logs/rocks and walls dust-
ing them with a soft brush. Glass liners can be cleaned
with household glass cleaner. Dust can also be re-
moved from the burner using a soft brush after remov-
ing the ceramic logs. When cleaning, make sure that
no particles are brushed into the slots of the burner.
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass or vermiculite particles as
these could be ingested by small children. Vacuum
thoroughly around the fi replace area after cleaning.
To refi t the window:
1. Place the window in its bottom railing. Ensure to
remove any vermiculite or glass particles in
the railing before installing the window.
Bottom railing
2. Push the top
of the window
frame against
the fi rebox.
Owner's Information
Window frame
Section Views
2
1
Valve
3. While you hold it, pull the side levers back into the
window brackets on each side.
3
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
OWNER'S
INFORMATION
7
Advertisement
Table of Contents
