Table of Contents
Advertisement
OWNER'S
INFORMATION
6. Reinstall the barrier screen on the trim.
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fireplace front
after maintenance.
a) 1555 1" trim: Insert the screen's top tabs in the
slots in the convection baffl e then rest the screen
bottom tabs on the edge of the opening in the
plinth to lock it in position.
b) 1550 3.5" and 1570 trims: Hook the bottom
of the screen to the bottom edge of the trim's
front plate, then, with the top levers up, push the
screen against the fi replace. Rotate the levers
down to hook them up to the trim and slide them
inwards to secure them.
7. Verify that the screen is properly hooked to the trim
and secure.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Pilot Flame can be seen
between the front and
rear left logs
Driftwood Kit Correct Flame Picture
Pilot Flame can
be seen left of
the fi re bed
Decorative Glass Murano Correct Flame Picture
Decorative Glass Correct Flame Picture
Pilot Flame can
be seen left of
the fi re bed
Rock & Shale Kit Correct Flame Picture
8
Owner's Information
Pilot Flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Batteries
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit.
Low batteries signal: see page 15.
BEFORE changing the batteries, turn the fi replace
off (including pilot).
The appliance uses four 1.5 V AA alkaline batteries
located next to the wall switch and one 9 V alkaline
battery in its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life.
To replace the batteries:
The battery holder is located next to the wall switch in
the vicinity of the fi replace. Its front plate is attached
with magnets to the wall switch box.
The battery holder is located beside the wall switch.
Thermocouple Probe
must be in Flame
WARNING
!
CAUTION
Battery holder
& wall switch
Fireplace
Advertisement
Table of Contents
