Yamaha YJ125S Service Manual page 45

1 Seat lock cable
2 Carburetor heater lead
3 Carburetor autochoke lead
4 Starter switch lead
5 Starter motor positive lead
6 Starter motor negative lead
7 High tension cord
8 Clamp
9 C.D.I. magneto lead
0 Vacuum sensing hose
q Joint
w Carburetor air vent hose
e Starter air vent hose
r Wire (positive lead)
A Pass the sidestand switch
lead under the rear brake
cable and throttle cable 1,2.
B Pass the sidestand switch
lead under the frame.
1
B
A
M
C Pass the throttle cable, wire
harness and rear brake
cable under the frame cross
tube.
D Pass the thermo switch lead
under the frame.
E Pass the positive and nega-
tive battery leads through the
slot in the footrest board.
F Fasten the autochoke lead
and heater lead to the cross
tube and cut the end to be
shorter than 5mm.
G Fasten the vacuum sensing
hose, starter motor positive
lead, C.D.I. magneto lead
and high tension cord, and
the vacuum sensing hose to
the over position and cut the
end.
F
D
E
C 2
r
L
CABLE ROUTING
G
9
4
8
6 7
5
3
K
w
J
e
2-30
SPEC
H Clamp the starter motor lead
and C.D.I. magneto lead.
I Pass the fuel overflow hose
along the left side of the fuel
tank.
J Route the autochoke lead
and heater lead between
vacuum sensing hose and
fuel cock vacuum hose.
K Pass the breather hose right
side the throttle cable.
L Fasten the breather hose,
autochoke lead, heater lead
and throttle cable 1, 2.
Breather hose to the over
position and cut the end.
M Pass the throttle cable, wire
harness and rear brake
cable outside the inner
fender rib.
H
0
q
1
I