Setting The Clock; Setting The Total Kilometres - VDO X2DW Instruction Manual

GB SLO PL JP
step 4 Also mark this spot on the ground.
step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
How to set the wheel size manually:
Using go to SETTINGS/
SELECT. Confirm with M
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode)
Using go to WHEELSIZE/
SET. Confirm with M .
MEASUREMENT/KMH.
Confirm with M or to
change to MPH.
14 X2DW
WHEELSIZE/BIKE 1.
(use to go to setting for
bike 2) Confirm with M .
Using go to
WHEEL-SIZE/MANUAL SET.
Confirm with M .
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
Confirm the entry with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.
Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
any wheel sizes, the computer works with these
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.
VDO CYCLECOMPUTING

5.3 Setting the clock

How to set the clock:
Using go to SETTINGS/
SELECT. Confirm with
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode)
Using go to CLOCK/SET.
Confirm with
.
CLOCK/24-H-MODE (you can
switch to 12-H mode using
Confirm with

5.4 Setting the total kilometres

You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).
Using go to SETTINGS/
SELECT. Confirm with
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
www.vdocyclecomputing.com
CLOCK...SET HOUR/CONTINUE
M . Set the hours using
Confirm the hour setting
with
CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using
. minutes setting with
M
CLOCK/SET OK? Confirm with
The display confirms: CLOCK/SET DONE.
. Automatic return to SETTINGS/SELECT.
M .
Using
SET. Confirm with
M .
ODOMETER/ODO BIKE 1
(use
BIKE 2). Confirm with
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
JP PL SLO GB
.
M .
. Confirm the
.
M
M .
go to ODOMETER/
M .
to go to setting for
M .
X2DW 15