Figure 4- Install Rail Assemblies; Figure 5- Adjust Distance Between Rails - NTI RACKMUX-V15 Installation And Operation Manual

NTI RACKMUX-V15/17 RACKMOUNT LCD MONITOR WITH KEYBOARD AND MOUSE
4. Install the right rail assembly.
screw through the rail flange to the rack support and cage nut using the #10-32 x 1/2" flat head machine screw provided. (See
image below.) Do not tighten at this time.
mounts to the front rack support.
5. Install two #10-32 x 3/4" pan-head screws in the rear of each rail assembly as shown below. Do not tighten at the time.
Install one flat
head screw in
the center in
each side at the
front
Rack Front
6. Measure the distance between the inside of the rails at the front of the rack. Adjust the distance to 17-1/4" and tighten the flat-
head screws to the rail flanges securely.
The end with the label "Right Front" mounts to the front rack support. Install only the center
Install the left rail assembly in the same fashion. The end with the label "Left Front"

Figure 4- Install rail assemblies

Left Rail
17-1/4"
Front Rack Supports

Figure 5- Adjust distance between rails

Rack Rear
Right Rail
5
Install two
screws in each
side at the rear