Figure 2- Install The Cage Nuts; Figure 3- Install The Rail Assemblies - NTI RACKMUX Series Installation Manual

NTI RACKMUX-4K17-N-16HD4K RACKMOUNT DRAWER WITH 4K VIDEO USB KVM SWITCH
3. Install six #10-32 cage nuts at the front of the rack in positions where the RACKMUX will be mounted (three in each side).
Install four more cage nuts at the rear of the rack in positions straight across from the upper and lower cage nuts installed in front.
4. Install the right rail assembly.
screw through the rail flange to the rack support and cage nut using the #10-32 x 1/2" flat head machine screw provided. (See
image below.) Do not tighten at this time.
mounts to the front rack support.
5. Install two #10-32 x 3/4" pan-head screws in the rear of each rail assembly as shown below. Do not tighten at the time.
Install one flat
head screw in
the center in
each side at
the front
Rack Front
Extender Rail
Extender Rail
Front Rack
Support
Rail Flange

Figure 2- Install the cage nuts

The end with the label "Right Front" mounts to the front rack support. Install only the center
Install the left rail assembly in the same fashion. The end with the label "Left Front"

Figure 3- Install the rail assemblies

Cage
Nuts
Rear Rack
Support
Cage
Nuts
Rack Rear
3
Install two
screws in each
side at the rear