Enabling Pv Testing For A Product - Loma IQ3+ User Manual

6. You can now enter or select the appropriate test parameters which are listed and described
in the PVS Setup
7.
Tap on the Back button
green tick 'OK' button to save the changes and close the screen. The Tracker feature is now
enabled and can be selected for use with any product

Enabling PV Testing for a Product

To enable PV testing for a product, proceed as follows:
1. Navigate to the Product Settings screen for the required product and tap on the PVS option
check box to enable the option. A number of other parameters will then be displayed.
2. You can now enter values for the PVS test parameters which are listed and described in the
Product Settings
3.
Tap on the Back button
green tick 'OK' button to save the changes and close the screen. The Tracker feature is now
enabled for the selected product
screen section.
to display the Save Settings pop-up screen. Then tap on the
screen section.
to display the Save Settings pop-up screen. Then tap on the
Operating Instructions
207