Emission-Control System Maintenance; Spark Plugs - Mitsubishi OUTLANDER Manual

Emission-control system maintenance

Your vehicle is equipped with an emission-control system that
meets all the requirements of the U.S. Environmental Protec-
tion Agency and Environment Canada. The emission-control
system is made of:
a positive crankcase ventilation system
an evaporative emission-control system
an exhaust emission-control system
To be sure the emission-control system works properly, have
your vehicle inspected and maintained by an authorized
Mitsubishi Motors dealer or a repair facility of your choice.
This should be done at the time or mileage specified in the
"WARRANTY AND MAINTENANCE MANUAL".
These, and all the other "general" maintenance services listed
in this manual, need to be performed to keep your vehicle run-
ning properly and reliably.
You should also have an inspection and service any time you
suspect a malfunction.
NOTE
To meet government regulations and promote cleaner air,
your vehicle is equipped with an onboard diagnostic sys-
tem (OBD). The engine electronic control module that
controls OBD functions stores various data (especially
about the exhaust emissions). This data will be erased if
the battery cable is disconnected, which could make a
rapid diagnosis difficult. Do not disconnect the battery
cable when the engine malfunction indicator ("SERVICE
ENGINE SOON" or "Check engine light") is ON.

Spark plugs

N00940800328
Spark plugs must fire properly to ensure proper engine perfor-
mance and emission-control.
Do not reuse spark plugs by cleaning or regapping. Spark plugs
should be replaced at the mileage specified in the "WAR-
RANTY AND MAINTENANCE MANUAL".
NOTE
Use the recommended or equivalent spark plugs listed
under "Engine specifications" on page 9-9. Use of other
plugs could cause engine damage, loss of performance or
radio noise.
Fuel hoses
Check the hose surfaces for any heat and mechanical damage,
hard and brittle rubber, cracking, tears, cuts and abrasions. Pay
special attention to the hoses closest to high heat sources such
as the exhaust manifold. Check all the hose connections, such
as clamps and couplings, to make sure they are secure and that
there are no leaks. If you see any wear or damage, replace the
hoses immediately.
Intake valve clearance
Have the valve clearance checked at an authorized Mitsubishi
Motors dealer at the mileage specified in the "WARRANTY
AND MAINTENANCE MANUAL".
If the engine sounds abnormally loud, have adjustments made
by an authorized Mitsubishi Motors dealer.
Vehicle care and maintenance
N00940900231
N00941000040
N00950100050
7-35
7