Mitsubishi OUTLANDER Manual page 338

NOTE
While the welcome light function is operating, perform
one of the following operations to cancel the function.
• Push the LOCK button (B) on the remote control trans-
mitter.
• Turn the combination headlights and dimmer switch to
the " " or " " position.
• Turn the ignition switch to the "ON" position.
It is possible to modify functions as follows:
• The headlights can be set to come on in the low beam
setting.
• The welcome light function can be deactivated.
For details, consult a Mitsubishi Motors dealer.
On vehicles equipped with Mitsubishi Multi-Communica-
tion System, screen operations can be used to make the
adjustment.
Refer to separate owner's manual for details.
Coming home light
This function turns on the headlights in the low beam setting
for about 30 seconds after the ignition switch is turned to the
"LOCK" position.
1. Turn the combination headlights and dimmer switch to the
"OFF" or "AUTO" position (for vehicles equipped with
the automatic light control).
2. Turn the ignition switch to the "LOCK" position. Also, if
a key was used to start the engine, remove the key from
the ignition switch.
3. Within 60 seconds of turning the ignition switch to the
"LOCK" position, pull the turn signal lever toward you.
Features and controls
N00547300070
3
3-223