Expansion Card Installation Procedure For A Pc Using Windows Nt - Fujitsu Deskpower 5000 Series User Manual

Point
- A device driver selected by the Plug & Play function has already been registered with
Windows 95/98. However, some device drivers have not been registered with Windows 95/
98, depending on the expansion card or peripheral device. In this case, use the floppy disk
included with the expansion card containing the device drivers to set up the driver in
accordance with the messages.
- Confirm that the device driver has been registered by the device manager before using the
expansion card. If not registered, delete the device driver and restart Windows 95/98.
Expansion card installation procedure for a PC using
Windows NT
○ ○ ○ ○ ○ ○ ○ ○
Install the expansion card.
See "Installing an
expansion card"
subsequently
described in this
section.
Lock the resources.
Start
Before installing the expansion card,
check the resources that can be set for
the expansion card to be installed.
Are the resources required by the expansion
card unused resources of the PC?
Yes
Release the resources by
disabling the expansion card or
the hardware that will not be used
by the PC.
Is the expansion card to be installed
Plug & Play compatible?
Yes
Register the resources required by
the expansion card.
Allocate the resources required by
the expansion card to idle resources
of the PC (by pin setting for resource
allocation).
Install the expansion card.
Set the device driver for the expansion card.
End. The expansion card is ready for use.
See the manual included with the
expansion card.
No
See the manual included with the
expansion card.
No
For the allocation procedure, see the manual
included with the expansion card.
See the manual included with the
expansion card.
For the setup procedure, see the
manual included with the expansion
card.
3
29