Hints And Tips - Currys Essentials CFSG10WH Instruction & Installation Manual

Hints and Tips

Problem
My hob burner does
not light
My burner flames are
yellow or hard to start
One of my burners
has an uneven flame
My burner goes out
when I let go of the
control
The flame goes out at
low settings
My burners do not
turn down much
(when running on
bottled gas or LPG)
The flame tips are very
yellow
There are
objectionable odours
The flame appears to
lift off the burner
There is an electricity
failure
• Check the cooker is switched on.
• Check the gas supply valve is turned on and the supply to the house is working. You
should hear the gas when you turn a burner on.
• The ignitors may be dirty. Clean them gently with a small nylon brush such as a
toothbrush.
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting flat.
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting flat.
• If you use bottled gas this may indicate you are getting near the end of the bottle.
• Check the burner parts are clean and dry.
• The gas pressure may not be at the correct level.
• Check with your approved service agent.
• Your cooker may not be set up for the gas you are using. Check this with your
approved service agent.
• Check the burner parts are clean and dry. Check the assembly and make sure the
burner cap is sitting flat.
• Cookers have a safety feature called 'Flame supervision Device (FSD)' . Hold in the
control for approximately 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the flame.
• The gas supply pressure may be low. Check this with your qualified technician.
• The low setting may have been adjusted incorrectly.
• Check this with your approved service agent.
• Your burners may not have been adjusted correctly. Check this with your approved
service agent.
• Call your approved service agent.
• Call your approved service agent.
• Call your approved service agent.
• If there is an electricity failure, you can still use your cooker. Light the burners by
holding a match close to the side of the burner and turning the controls to the High
position. Wait until the flame is burning evenly before adjusting. The control must
still be held in for 10 seconds after the burner has lit. Releasing the control too soon
will extinguish the flame.
Possible Solutions
17