Table of Contents
Advertisement
Gas Connection
The installation of the cooker to Natural Gas or LP Gas must be carried out by a Gas Safe registered engineer.
Installers must take account of the provisions of the relevant British Standards Code of Practice, the Gas Safety
Regulations and the Building Regulations.
It is recommended that the gas connection to the cooker is installed with a flexible connecting tube
made to BS669.
Installation Relevant to Natural Gas
Installation to Natural Gas must conform to the Industry Standards, etc. The supply pressure for Natural Gas is
20 mbar.
Installation Relevant to Liquid Petroleum Gas (LPG)
This appliance must only be connected to LPG after an LPG conversion kit has been fitted. The installation must
conform to the relevant British Standards.
• Only a suitably qualified and Gas Safe Registered Engineer may
convert the appliance to a different gas type.
• When using Butane gas a supply pressure of 28 -30 mbar is
required.
• When using Propane gas a supply pressure of 37 mbar is
required.
• Flexible hoses can be used where the sited ambient temperature
of the hose does not exceed 70°C. These hoses must be
manufactured in accordance with BS669 part 1 and be of the
correct construction for the type of gas being used.
• Gas hoses designed for natural gas MUST NOT be used for
supplying LPG gas (LPG gas hoses can be identified by a either a
red band or stripe on the rubber outer coating of the hose).
• The hose should not be crushed or trapped or be in contact
with sharp or abrasive edges. It should also not be subjected to
corrosion by acidic cleansing agents.
22
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CFSG10WH and is the answer not in the manual?