Table of Contents
Advertisement
To Connect the Gas Supply:
1.
Connect the gas supply to the right or left gas inlet at the rear of the cooker. The gas hose must hang in a "U"
behind the cooker.
2.
Close the unused end inlet pipe with a plug.
3.
Undertake a full gas tightness test.
4.
To avoid damage to the appliance gas rail inlet pipe tighten the fittings using two suitable spanners.
5.
Using a suitable leak detection fluid solution check each gas connection one at a time by brushing the
solution over the connection. The presence of bubbles will indicate a leak. If there is a leak, tighten the fitting
and then recheck for leaks.
Do not use a naked flame to test for leaks.
Rear wall
Area for gas mains connection.
Bayonet location should be
approximately 650/700 mm above the
finished floor level.
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CFSG10WH and is the answer not in the manual?
Questions and answers