Lighting The Burners; Flame Failure Safety Feature; If The Burner Does Not Light; If The Flame Is Irregular - Currys Essentials CFSG10WH Instruction & Installation Manual

Lighting the Burners

1. Choose the control for the burner you want to use.
2. Press the Ignition switch and at the same time gently press and hold the burner control in and then turn it
anti-clockwise to the
Continue to hold the control in for approximately 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the flame.
3. Adjust the flame anywhere between the and
position.
• If the burner does not light within 15 seconds, turn the control off and wait for at least one minute
before trying again.
• To switch the burner off, turn the control clockwise to the OFF position and you will hear the
safety click.
• After use, always turn the controls to the OFF position.

Flame Failure Safety Feature

The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold the control in for approximately 10 seconds after the burner has lit. Releasing the
control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one
minute (to allow the gas to disperse).

If the Burner does not Light

If the burner does not light, check that:
• The cooker is switched on.
• The gas is turned on.
• You have held the control in for at least ten
seconds.
• The ignitors are sparking. If the ignitors are
not sparking, they may be dirty or wet. Clean
them gently with a small nylon brush such as a
toothbrush as shown below.

If the Flame is Irregular

If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
• Clean and dry.
• Positioned correctly. See 'Replacing the Burners' .
• Also see 'Hints and Tips' .
8
position. Release the Ignition switch once the burner is lit.
positions. Do not adjust the flame between the
Ignitor
and OFF
Flame failure
probe